compression checker Gauge

Smelly_Cat · « **on:** August 27, 2007, 09:37:44 PM »

Hey Zen, have you got a compression checker Gauge I can Borrow?
I want to check this toyota van that I put a head gasket in. and I can't figure out what the heck is wrong with it. It runs on 1 cly which is pretty good and beats my last repair on Stupie when I ran on 2 pistons. but I think 4 cyl's would be better

SC

Ret.Bugtech · « **Reply #1 on:** August 28, 2007, 09:21:44 AM »

Hey S.C. 4 clys are always good unless you have a 6 cly. :lol:
A comp. check would be good. I don't know a cotton-pick'n thing about a Toyota and don't want to . Just remember that Kenmore and Maytag parts boxes plus a pint of Permatex does not a head gasket make. :roll: Good Luck !!

Smelly_Cat · « **Reply #2 on:** August 29, 2007, 05:51:18 PM »

I think I have plugwireretardation, When ever i plug the wires in a car engine,,, I do it wrong. If I had a one cly lawn mower I'd problay screw that up too. On this bloomin toy van I had them all wrong except one. Golly I quit. SC

Zen · « **Reply #3 on:** August 29, 2007, 09:06:07 PM »

Quote from: "Smelly_Cat"

Hey Zen, have you got a compression checker Gauge I can Borrow?

No. Not that I wouldn't loan it to ya' . . . I don't own one.

Quote from: "Smelly_Cat"

I think I have plugwireretardation

Don't feel too bad. That's a big problem here in the "triangle." I've had a bad case or two of it myself. I hear that there was a local shortage of the vaccine for it back in our childhood years. :wink:

Forums

Topic: compression checker Gauge (Read 1638 times)

Smelly_Cat

compression checker Gauge

Ret.Bugtech

compression checker Gauge

Smelly_Cat

compression checker Gauge

Zen

Re: compression checker Gauge

About Us

Follow Us

Contact Us